EK-FC680 GTX SOC water block detailed

Water block solution is one of the best solution for over-clockers and zero noise lovers, EK Water Blocks today introduced a new water block the "EK-FC680" to target the Nvidia's GTX 680 from Gigabyte, the Gigabyte's Super Overclock SOC (GV-N680SO-2GD) edition graphic card.

The new water block is a full cover design with high conductive plated electrolytic copper materials for best performance, check out the PR bellow.

This water block directly cools the GPU, RAM as well as VRM (voltage regulation module) as water flows directly over these critical areas thus allowing the graphics card and it's VRM to remain stable under high overclocks. EK-FC680 GTX SOC water block also features a very high flow design therefore it can be easily used in liquid cooling systems using weaker water pumps.
Base is made of nickel plated electrolytic copper while the top is made of quality POM Acetal material. The sealing is performed by quality rubber washers. Screw-in brass standoffs are pre-installed and allow for safe, painless installation procedure. Block is mounted with enclosed M3x4 DIN7985 screws and plastic washers.
EK also encloses two-slot I/O bracket which replaces the original three-slot, in order to make installation of mutliple graphics cards easier.

Up to four EK-FC680 GTX SOC series water blocks can be interconnected with EK-FC Bridge & Link system. Additionally this water block lines up with EK-FC680 GTX(+) as well as EK-FC680 GTX FTW series water blocks thus even further expanding users choice of graphics cards. The correct connection link for this water block is already enclosed with the product.

- EK-FC680 GTX SOC series water block
- EK-FC Link
- 2-slot I/O bracket
- mounting mechanism with screw-in brass standoffs
- thermal pads

Product pictures:

If you like this article, please share it on facebook, tweet it and +1 it to spread it :) !
EK-FC680 GTX SOC water block detailed EK-FC680 GTX SOC water block detailed Reviewed by Mhr on 22:24 Rating: 5

No comments

No Backlinks please, Comments are under moderation !